The timing marks are located on the crank pulley or whats considered the harmonic balancer there will be a notch or a tick mark then there is the one on the cam shaft gear which is on the cam gear, I believe the mark has a location on the cylinder head by the cam gear, I'll tell you the torque specs are like this. From the center and working left top right bottom like this
9 5 1 3 7
10 6 2 4 8
that is the torque sequence, you must remove the head in the reverse sequence or you coulod warp or crack the head or cam, then you just time the motor up when the head is off. I'll watch this page if you have any other questions....
9 5 1 3 7
10 6 2 4 8
that is the torque sequence, you must remove the head in the reverse sequence or you coulod warp or crack the head or cam, then you just time the motor up when the head is off. I'll watch this page if you have any other questions....