Take the plastic bits off from around the steering coloum so you can see the what the ignition barrel is fitted in to, it will be a cylindrical housing on the steering coloum. Put the key in the ignition barrel turn it to one of the positions marked where the key goes in, it's either a quarter or half turn till it clicks. You will see little pins sticking out the side of the housing where the barrel sit's in, they will push in when the key is turned to the right setting, use a thin screwdriver or nail. The barrel will just pull out by the key then unclip the connector's at the rear.
You might of lost your keys though asking this question? If so just batter it out with a hammer an chisel...
Good luck! :)
You might of lost your keys though asking this question? If so just batter it out with a hammer an chisel...
Good luck! :)